Adjust spacing in pins_RAMPS_13.h

This commit is contained in:
Scott Lahteine 2015-08-02 19:23:04 -07:00 committed by Richard Wackerbarth
parent 56702e7bb9
commit 267f3479d7

View File

@ -69,48 +69,48 @@
#if MB(RAMPS_13_EEB) && ENABLED(FILAMENT_SENSOR) // FMM added for Filament Extruder
// define analog pin for the filament width sensor input
// Use the RAMPS 1.4 Analog input 5 on the AUX2 connector
#define FILWIDTH_PIN 5
#define FILWIDTH_PIN 5
#endif
#if ENABLED(Z_PROBE_ENDSTOP)
// Define a pin to use as the signal pin on Arduino for the Z_PROBE endstop.
#define Z_PROBE_PIN 32
#define Z_PROBE_PIN 32
#endif
#if ENABLED(FILAMENT_RUNOUT_SENSOR)
// define digital pin 4 for the filament runout sensor. Use the RAMPS 1.4 digital input 4 on the servos connector
#define FILRUNOUT_PIN 4
#define FILRUNOUT_PIN 4
#endif
#if MB(RAMPS_13_EFF) || ENABLED(IS_RAMPS_EFB)
#define FAN_PIN 9 // (Sprinter config)
#define FAN_PIN 9 // (Sprinter config)
#if MB(RAMPS_13_EFF)
#define CONTROLLERFAN_PIN -1 // Pin used for the fan to cool controller
#endif
#elif MB(RAMPS_13_EEF) || MB(RAMPS_13_SF)
#define FAN_PIN 8
#define FAN_PIN 8
#else
#define FAN_PIN 4 // IO pin. Buffer needed
#define FAN_PIN 4 // IO pin. Buffer needed
#endif
#define PS_ON_PIN 12
#if ENABLED(REPRAP_DISCOUNT_SMART_CONTROLLER) || ENABLED(G3D_PANEL)
#define KILL_PIN 41
#define KILL_PIN 41
#else
#define KILL_PIN -1
#define KILL_PIN -1
#endif
#if MB(RAMPS_13_EFF)
#define HEATER_0_PIN 8
#define HEATER_0_PIN 8
#else
#define HEATER_0_PIN 10 // EXTRUDER 1
#define HEATER_0_PIN 10 // EXTRUDER 1
#endif
#if MB(RAMPS_13_SF) || ENABLED(IS_RAMPS_EFB)
#define HEATER_1_PIN -1
#define HEATER_1_PIN -1
#else
#define HEATER_1_PIN 9 // EXTRUDER 2 (FAN On Sprinter)
#define HEATER_1_PIN 9 // EXTRUDER 2 (FAN On Sprinter)
#endif
#define HEATER_2_PIN -1
@ -120,9 +120,9 @@
#define TEMP_2_PIN -1 // ANALOG NUMBERING
#if MB(RAMPS_13_EFF) || MB(RAMPS_13_EEF) || MB(RAMPS_13_SF)
#define HEATER_BED_PIN -1 // NO BED
#define HEATER_BED_PIN -1 // NO BED
#else
#define HEATER_BED_PIN 8 // BED
#define HEATER_BED_PIN 8 // BED
#endif
#define TEMP_BED_PIN 14 // ANALOG NUMBERING