RigidBot CONTROLLERFAN_PIN in Configuration_adv.h

This commit is contained in:
Scott Lahteine 2015-07-08 15:32:03 -07:00 committed by Richard Wackerbarth
parent f068e46661
commit 536f86e896
2 changed files with 1 additions and 3 deletions

View File

@ -85,7 +85,7 @@
//This is for controlling a fan to cool down the stepper drivers //This is for controlling a fan to cool down the stepper drivers
//it will turn on when any driver is enabled //it will turn on when any driver is enabled
//and turn off after the set amount of seconds from last driver being disabled again //and turn off after the set amount of seconds from last driver being disabled again
#define CONTROLLERFAN_PIN -1 //Pin used for the fan to cool controller (-1 to disable) #define CONTROLLERFAN_PIN 4 //Pin used for the fan to cool motherboard (-1 to disable) // RigidBot: Fans/Water Pump to cool the hotend cool side.
#define CONTROLLERFAN_SECS 60 //How many seconds, after all motors were disabled, the fan should run #define CONTROLLERFAN_SECS 60 //How many seconds, after all motors were disabled, the fan should run
#define CONTROLLERFAN_SPEED 255 // == full speed #define CONTROLLERFAN_SPEED 255 // == full speed

View File

@ -4,8 +4,6 @@
#include "pins_RAMPS_13.h" #include "pins_RAMPS_13.h"
#define CONTROLLERFAN_PIN 4 //Pin used for the fan to cool motherboard (-1 to disable) //Fans/Water Pump to cool the hotend cool side.
#ifdef Z_PROBE_ENDSTOP #ifdef Z_PROBE_ENDSTOP
#define Z_PROBE_PIN 19 #define Z_PROBE_PIN 19
#endif #endif