Tweak comments

This commit is contained in:
Scott Lahteine 2015-04-18 23:12:29 -07:00
parent 47847765e2
commit d931220a65

View File

@ -184,7 +184,7 @@
* M405 - Turn on Filament Sensor extrusion control. Optional D<delay in cm> to set delay in centimeters between sensor and extruder * M405 - Turn on Filament Sensor extrusion control. Optional D<delay in cm> to set delay in centimeters between sensor and extruder
* M406 - Turn off Filament Sensor extrusion control * M406 - Turn off Filament Sensor extrusion control
* M407 - Display measured filament diameter * M407 - Display measured filament diameter
* M410 - Quickstop - Abort all the planned moves * M410 - Quickstop. Abort all the planned moves
* M500 - Store parameters in EEPROM * M500 - Store parameters in EEPROM
* M501 - Read parameters from EEPROM (if you need reset them after you changed them temporarily). * M501 - Read parameters from EEPROM (if you need reset them after you changed them temporarily).
* M502 - Revert to the default "factory settings". You still need to store them in EEPROM afterwards if you want to. * M502 - Revert to the default "factory settings". You still need to store them in EEPROM afterwards if you want to.
@ -4378,7 +4378,7 @@ inline void gcode_M400() { st_synchronize(); }
#endif // FILAMENT_SENSOR #endif // FILAMENT_SENSOR
/** /**
* M410: quickstop - Abort all planned moves * M410: Quickstop - Abort all planned moves
* *
* This will stop the carriages mid-move, so most likely they * This will stop the carriages mid-move, so most likely they
* will be out of sync with the stepper position after this. * will be out of sync with the stepper position after this.