History

Scott Lahteine e37a1ded0d Increase BABYSTEP_MULTIPLICATOR to 100 Ideally, it should be calculated based on Z steps per unit so that each babystep corresponds to around 0.025mm. Smaller than this is largely insignificant for typical layer heights.		2017-09-27 00:14:26 -05:00
..
_Bootscreen.h	Arrange example configurations by vendor	2017-07-07 04:48:23 -05:00
Configuration_adv.h	Increase BABYSTEP_MULTIPLICATOR to 100	2017-09-27 00:14:26 -05:00
Configuration.h	Update links to old wiki page	2017-09-23 22:06:45 -05:00
README.md	Arrange example configurations by vendor	2017-07-07 04:48:23 -05:00

Configuration for Malyan M150 hobbyking printer

config without automatic bed level sensor