Apply const to some planner vars

This commit is contained in:
Scott Lahteine 2017-11-29 21:02:29 -06:00
parent fd78446b2b
commit 23e45fa3c4

View File

@ -1316,8 +1316,8 @@ void Planner::_buffer_line(const float &a, const float &b, const float &c, const
// then the machine is not coasting anymore and the safe entry / exit velocities shall be used.
// The junction velocity will be shared between successive segments. Limit the junction velocity to their minimum.
bool prev_speed_larger = previous_nominal_speed > block->nominal_speed;
float smaller_speed_factor = prev_speed_larger ? (block->nominal_speed / previous_nominal_speed) : (previous_nominal_speed / block->nominal_speed);
const bool prev_speed_larger = previous_nominal_speed > block->nominal_speed;
const float smaller_speed_factor = prev_speed_larger ? (block->nominal_speed / previous_nominal_speed) : (previous_nominal_speed / block->nominal_speed);
// Pick the smaller of the nominal speeds. Higher speed shall not be achieved at the junction during coasting.
vmax_junction = prev_speed_larger ? block->nominal_speed : previous_nominal_speed;
// Factor to multiply the previous / current nominal velocities to get componentwise limited velocities.
@ -1449,7 +1449,7 @@ void Planner::_set_position_mm(const float &a, const float &b, const float &c, c
#else
#define _EINDEX E_AXIS
#endif
long na = position[X_AXIS] = LROUND(a * axis_steps_per_mm[X_AXIS]),
const long na = position[X_AXIS] = LROUND(a * axis_steps_per_mm[X_AXIS]),
nb = position[Y_AXIS] = LROUND(b * axis_steps_per_mm[Y_AXIS]),
nc = position[Z_AXIS] = LROUND(c * axis_steps_per_mm[Z_AXIS]),
ne = position[E_AXIS] = LROUND(e * axis_steps_per_mm[_EINDEX]);