M420 can now enable/disable ABL

This commit is contained in:
Scott Lahteine 2016-09-29 01:03:28 -05:00
parent 06790977c4
commit 56cf674150

View File

@ -225,7 +225,7 @@
* M406 - Disable Filament Sensor flow control. (Requires FILAMENT_WIDTH_SENSOR)
* M407 - Display measured filament diameter in millimeters. (Requires FILAMENT_WIDTH_SENSOR)
* M410 - Quickstop. Abort all planned moves.
* M420 - Enable/Disable Mesh Leveling (with current values) S1=enable S0=disable (Requires MESH_BED_LEVELING)
* M420 - Enable/Disable Leveling (with current values) S1=enable S0=disable (Requires MESH_BED_LEVELING or ABL)
* M421 - Set a single Z coordinate in the Mesh Leveling grid. X<units> Y<units> Z<units> (Requires MESH_BED_LEVELING)
* M428 - Set the home_offset based on the current_position. Nearest edge applies.
* M500 - Store parameters in EEPROM. (Requires EEPROM_SETTINGS)
@ -6312,12 +6312,14 @@ void quickstop_stepper() {
SYNC_PLAN_POSITION_KINEMATIC();
}
#if ENABLED(MESH_BED_LEVELING)
#if PLANNER_LEVELING
/**
* M420: Enable/Disable Mesh Bed Leveling
* M420: Enable/Disable Bed Leveling
*/
inline void gcode_M420() { if (code_seen('S')) mbl.set_has_mesh(code_value_bool()); }
inline void gcode_M420() { if (code_seen('S')) set_bed_leveling_enabled(code_value_bool()); }
#endif
#if ENABLED(MESH_BED_LEVELING)
/**
* M421: Set a single Mesh Bed Leveling Z coordinate
@ -7343,11 +7345,11 @@ void process_next_command() {
gcode_G28();
break;
#if HAS_ABL || ENABLED(MESH_BED_LEVELING)
#if PLANNER_LEVELING
case 29: // G29 Detailed Z probe, probes the bed at 3 or more points.
gcode_G29();
break;
#endif // HAS_ABL
#endif // PLANNER_LEVELING
#if HAS_BED_PROBE