Include RIGIDBOT_PANEL in Conditionals

This commit is contained in:
Scott Lahteine 2015-08-02 13:56:49 -07:00 committed by Richard Wackerbarth
parent 3cfe1dce1f
commit 68055a5959
2 changed files with 2 additions and 2 deletions

View File

@ -58,7 +58,7 @@
#define REPRAP_DISCOUNT_SMART_CONTROLLER #define REPRAP_DISCOUNT_SMART_CONTROLLER
#endif #endif
#if ENABLED(ULTIMAKERCONTROLLER) || ENABLED(REPRAP_DISCOUNT_SMART_CONTROLLER) || ENABLED(G3D_PANEL) #if ENABLED(ULTIMAKERCONTROLLER) || ENABLED(REPRAP_DISCOUNT_SMART_CONTROLLER) || ENABLED(G3D_PANEL) || ENABLED(RIGIDBOT_PANEL)
#define ULTIPANEL #define ULTIPANEL
#define NEWPANEL #define NEWPANEL
#endif #endif

View File

@ -85,7 +85,7 @@
//This is for controlling a fan to cool down the stepper drivers //This is for controlling a fan to cool down the stepper drivers
//it will turn on when any driver is enabled //it will turn on when any driver is enabled
//and turn off after the set amount of seconds from last driver being disabled again //and turn off after the set amount of seconds from last driver being disabled again
#define CONTROLLERFAN_PIN 4 //Pin used for the fan to cool motherboard (-1 to disable) // RigidBot: Fans/Water Pump to cool the hotend cool side. #define CONTROLLERFAN_PIN 4 // RigidBot: Fans/Water Pump to cool the hotend cool side.
#define CONTROLLERFAN_SECS 60 //How many seconds, after all motors were disabled, the fan should run #define CONTROLLERFAN_SECS 60 //How many seconds, after all motors were disabled, the fan should run
#define CONTROLLERFAN_SPEED 255 // == full speed #define CONTROLLERFAN_SPEED 255 // == full speed