Merge pull request #768 from whosawhatsis/Marlin_v1

multiple FWretract fixes
This commit is contained in:
daid 2014-02-13 09:14:57 +01:00
commit 816f0a678a

View File

@ -137,8 +137,8 @@
// M204 - Set default acceleration: S normal moves T filament only moves (M204 S3000 T7000) im mm/sec^2 also sets minimum segment time in ms (B20000) to prevent buffer underruns and M20 minimum feedrate
// M205 - advanced settings: minimum travel speed S=while printing T=travel only, B=minimum segment time X= maximum xy jerk, Z=maximum Z jerk, E=maximum E jerk
// M206 - set additional homeing offset
// M207 - set retract length S[positive mm] F[feedrate mm/sec] Z[additional zlift/hop]
// M208 - set recover=unretract length S[positive mm surplus to the M207 S*] F[feedrate mm/sec]
// M207 - set retract length S[positive mm] F[feedrate mm/min] Z[additional zlift/hop], stays in mm regardless of M200 setting
// M208 - set recover=unretract length S[positive mm surplus to the M207 S*] F[feedrate mm/min]
// M209 - S<1=true/0=false> enable automatic retract detect if the slicer did not support G10/11: every normal extrude-only move will be classified as retract depending on the direction.
// M218 - set hotend offset (in mm): T<extruder_number> X<offset_on_X> Y<offset_on_Y>
// M220 S<factor in percent>- set speed factor override percentage
@ -1113,11 +1113,15 @@ void process_commands()
destination[X_AXIS]=current_position[X_AXIS];
destination[Y_AXIS]=current_position[Y_AXIS];
destination[Z_AXIS]=current_position[Z_AXIS];
current_position[Z_AXIS]+=-retract_zlift;
destination[E_AXIS]=current_position[E_AXIS]-retract_length;
current_position[Z_AXIS]-=retract_zlift;
destination[E_AXIS]=current_position[E_AXIS];
current_position[E_AXIS]+=retract_length/volumetric_multiplier[active_extruder];
plan_set_e_position(current_position[E_AXIS]);
float oldFeedrate = feedrate;
feedrate=retract_feedrate;
retracted=true;
prepare_move();
feedrate = oldFeedrate;
}
break;
@ -1128,10 +1132,14 @@ void process_commands()
destination[Y_AXIS]=current_position[Y_AXIS];
destination[Z_AXIS]=current_position[Z_AXIS];
current_position[Z_AXIS]+=retract_zlift;
destination[E_AXIS]=current_position[E_AXIS]+retract_length+retract_recover_length;
destination[E_AXIS]=current_position[E_AXIS];
current_position[E_AXIS]-=(retract_length+retract_recover_length)/volumetric_multiplier[active_extruder];
plan_set_e_position(current_position[E_AXIS]);
float oldFeedrate = feedrate;
feedrate=retract_recover_feedrate;
retracted=false;
prepare_move();
feedrate = oldFeedrate;
}
break;
#endif //FWRETRACT