EEPROM report uses G29 S3

This commit is contained in:
Scott Lahteine 2016-05-23 13:49:29 -07:00
parent 4955163959
commit 9049f4084b

View File

@ -62,7 +62,7 @@
* 201 z_offset (float) (added in V23)
* 205 mesh_num_x (uint8 as set in firmware)
* 206 mesh_num_y (uint8 as set in firmware)
* 207 M421 XYZ z_values[][] (float x9, by default)
* 207 G29 S3 XYZ z_values[][] (float x9, by default)
*
* AUTO BED LEVELING
* 243 M851 zprobe_zoffset (float)
@ -733,13 +733,13 @@ void Config_PrintSettings(bool forReplay) {
SERIAL_ECHOPAIR(" X", MESH_NUM_X_POINTS);
SERIAL_ECHOPAIR(" Y", MESH_NUM_Y_POINTS);
SERIAL_EOL;
for (uint8_t py = 0; py < MESH_NUM_Y_POINTS; py++) {
for (uint8_t px = 0; px < MESH_NUM_X_POINTS; px++) {
for (uint8_t py = 1; py <= MESH_NUM_Y_POINTS; py++) {
for (uint8_t px = 1; px <= MESH_NUM_X_POINTS; px++) {
CONFIG_ECHO_START;
SERIAL_ECHOPAIR(" M421 X", mbl.get_probe_x(px));
SERIAL_ECHOPAIR(" Y", mbl.get_probe_y(py));
SERIAL_ECHOPAIR(" G29 S3 X", px);
SERIAL_ECHOPAIR(" Y", py);
SERIAL_ECHOPGM(" Z");
SERIAL_PROTOCOL_F(mbl.z_values[py][px], 5);
SERIAL_PROTOCOL_F(mbl.z_values[py-1][px-1], 5);
SERIAL_EOL;
}
}