Firmware2/Marlin/src/lcd/extui/lib/mks_ui/irq_overrid.cpp
2020-11-19 15:56:04 -06:00

71 lines
2.0 KiB
C++

/**
* Marlin 3D Printer Firmware
* Copyright (c) 2020 MarlinFirmware [https://github.com/MarlinFirmware/Marlin]
*
* Based on Sprinter and grbl.
* Copyright (c) 2011 Camiel Gubbels / Erik van der Zalm
*
* This program is free software: you can redistribute it and/or modify
* it under the terms of the GNU General Public License as published by
* the Free Software Foundation, either version 3 of the License, or
* (at your option) any later version.
*
* This program is distributed in the hope that it will be useful,
* but WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
* GNU General Public License for more details.
*
* You should have received a copy of the GNU General Public License
* along with this program. If not, see <https://www.gnu.org/licenses/>.
*
*/
#include "../../../../inc/MarlinConfigPre.h"
#if HAS_TFT_LVGL_UI
#include "tft_lvgl_configuration.h"
#if ENABLED(MKS_WIFI_MODULE)
#include "draw_ui.h"
#include "wifiSerial.h"
#include <libmaple/libmaple.h>
#include <libmaple/gpio.h>
#include <libmaple/timer.h>
#include <libmaple/usart.h>
#include <libmaple/ring_buffer.h>
#include "../../../../inc/MarlinConfig.h"
#ifdef __cplusplus
extern "C" { /* C-declarations for C++ */
#endif
#define WIFI_IO1_SET() WRITE(WIFI_IO1_PIN, HIGH);
#define WIFI_IO1_RESET() WRITE(WIFI_IO1_PIN, LOW);
void __irq_usart1(void) {
WIFISERIAL.wifi_usart_irq(USART1_BASE);
if (wifi_link_state == WIFI_TRANS_FILE) {
if (WIFISERIAL.available() == (400)) WIFI_IO1_SET();
if (WIFISERIAL.wifi_rb_is_full()) {
if (esp_state == TRANSFER_IDLE) esp_state = TRANSFERING;
if (storeRcvData(UART_RX_BUFFER_SIZE)) {
if (wifiTransError.flag != 0x1) WIFI_IO1_RESET();
}
else {
WIFI_IO1_SET();
esp_state = TRANSFER_STORE;
}
}
}
}
#ifdef __cplusplus
} /* C-declarations for C++ */
#endif
#endif // MKS_WIFI_MODULE
#endif // HAS_TFT_LVGL_UI