Firmware2/Marlin/src/HAL/SAMD51/watchdog.cpp
2020-03-13 16:29:29 -05:00

54 lines
1.7 KiB
C++

/**
* Marlin 3D Printer Firmware
*
* Copyright (c) 2020 MarlinFirmware [https://github.com/MarlinFirmware/Marlin]
* SAMD51 HAL developed by Giuliano Zaro (AKA GMagician)
*
* This program is free software: you can redistribute it and/or modify
* it under the terms of the GNU General Public License as published by
* the Free Software Foundation, either version 3 of the License, or
* (at your option) any later version.
*
* This program is distributed in the hope that it will be useful,
* but WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
* GNU General Public License for more details.
*
* You should have received a copy of the GNU General Public License
* along with this program. If not, see <http://www.gnu.org/licenses/>.
*
*/
#ifdef __SAMD51__
#include "../../inc/MarlinConfig.h"
#if ENABLED(USE_WATCHDOG)
#include "watchdog.h"
void watchdog_init() {
// The low-power oscillator used by the WDT runs at 32,768 Hz with
// a 1:32 prescale, thus 1024 Hz, though probably not super precise.
// Setup WDT clocks
MCLK->APBAMASK.bit.OSC32KCTRL_ = true;
MCLK->APBAMASK.bit.WDT_ = true;
OSC32KCTRL->OSCULP32K.bit.EN1K = true; // Enable out 1K (this is what WDT uses)
WDT->CTRLA.bit.ENABLE = false; // Disable watchdog for config
SYNC(WDT->SYNCBUSY.bit.ENABLE);
WDT->INTENCLR.reg = WDT_INTENCLR_EW; // Disable early warning interrupt
WDT->CONFIG.reg = WDT_CONFIG_PER_CYC4096; // Set at least 4s period for chip reset
HAL_watchdog_refresh();
WDT->CTRLA.reg = WDT_CTRLA_ENABLE; // Start watchdog now in normal mode
SYNC(WDT->SYNCBUSY.bit.ENABLE);
}
#endif // USE_WATCHDOG
#endif // __SAMD51__